Illustration of a product in a box with one long arrow for total clearance and two short arrows for each side

Shipping & packaging

Total Clearance vs Clearance per Side

A clearance figure can mean two things: the total spare room along an axis, or the room on each side of the product. They differ by a factor of two, and mixing them up leads to boxes that are too tight or padding that doesn’t fit.

Ready to try the tool this guide describes?

Two numbers, one gap

Along each axis there are two walls. The total clearance is all the spare room between them; the clearance per side is how much sits on one side when the product is centered — half the total. In a 12 in long box, an 11 in product has 1 in of total clearance, or 0.5 in at each end.

Which one to use

Which one to use comparison
QuestionUse
Will the product fit?Total clearance (it must be zero or more)
How thick can the padding be?Clearance per side
How far can the product slide?Total clearance
How much bigger is the box?Total clearance

Height is different

End to end and side to side, a product can be centered. In height it usually rests on the bottom, so all the vertical clearance ends up on top unless something is placed underneath. If you need cushioning below, count it as part of the height clearance.

Orientation moves the room around

Turning a product changes which axis gets which gap. An 18 × 25 × 12 cm product doesn’t fit a 30 × 20 × 15 cm box as entered — 25 cm is wider than 20 cm. Turned so its 25 cm side runs along the 30 cm length, it has 5, 2, and 3 cm in total, or 2.5, 1, and 1.5 cm per side.

Uneven clearance

  • A product rarely has the same clearance on every axis; the tightest axis decides whether padding fits.
  • A large clearance on one axis lets the product slide that way unless the gap is filled.
  • When several orientations fit, the one with the most room at its tightest axis usually gives the most even protection.

Total vs Per-Side Clearance FAQ

Is clearance per side half of the total clearance?
Yes, when the product is centered between the two walls.
Which clearance matters for padding?
Clearance per side, because padding sits on each side of the product. Half an inch per side means padding no thicker than half an inch.
Why is there no clearance under my product?
Because it rests on the bottom of the box. Its height clearance is all above it unless something is placed underneath.
Can turning the product change the clearance?
Yes. Each orientation puts different product sides against different box sides, so the gaps change.
What if the clearance is different on each axis?
That is normal. Pay most attention to the smallest one: it limits the padding and decides how snug the fit is.

Related guides

Open the tool

Jump into Box Clearance Calculator when you are ready to process your files.

← Back to all guides

More from Looty

Explore Looty’s Ecosystem

Discover more ways Looty can help you learn, organize, create, and make an impact.