Illustration of a wheel lying flat with a straightedge across its back and a ruler down to the hub

Vehicles & EVs

How to Calculate Wheel Offset From Backspacing

Backspacing is easy to measure with a straightedge; offset is what wheel catalogs list. Converting one to the other needs one more figure: the wheel’s overall width.

Ready to try the tool this guide describes?

The formula

  1. Find the overall width: measure it flange edge to flange edge, or add a flange allowance to each side of the nominal width.
  2. Halve it to find the centerline’s distance from the back edge.
  3. Offset = backspacing − half the overall width.
  4. Multiply inches by 25.4 for millimeters.

Worked examples on an 8-inch wheel

Worked examples on an 8-inch wheel comparison
BackspacingOverall widthOffset
5.88 in9 in (assumed: 8 in + 0.5 in each side)+35.1 mm
6.5 in9 in (assumed)+50.8 mm
4.5 in9 in (assumed)0 mm
4 in9 in (assumed)−12.7 mm

Measured vs assumed width

The nominal width — the 8 in an 8×17 wheel — is measured between the bead seats, inside the flanges. A half-inch allowance per side is a common estimate, but real flanges vary. If the same 8-inch wheel actually measures 8.9 inches across, 5.88 inches of backspacing gives +36.3 mm instead of +35.1 mm.

Common mistakes

  • Using the nominal width as the overall width, which puts the centerline half an inch too close to the back edge and makes the offset about 12.7 mm too high.
  • Measuring backspacing to a hub-centric ring or a raised center instead of the flat mounting face.
  • Mixing inches and millimeters partway through.

Offset From Backspacing FAQ

How do I convert backspacing to offset?
Subtract half the wheel’s overall width from the backspacing. With 5.88 inches of backspacing on a 9-inch overall width, the offset is about +35 mm.
What flange allowance should I use?
About 0.5 inches per side is common, but measuring the overall width is more accurate.
What does backspacing less than half the width mean?
A negative offset: the mounting face is on the inner side of the centerline.
Why do I need the overall width?
Backspacing is measured from the outer edge of the back flange, so the centerline has to be found from the same edges.
Can I calculate backspacing from offset instead?
Yes — add the offset to half the overall width. The Wheel Backspacing Calculator does that direction.

Related guides

Open the tool

Jump into Wheel Offset Calculator when you are ready to process your files.

← Back to all guides

More from Looty

Explore Looty’s Ecosystem

Discover more ways Looty can help you learn, organize, create, and make an impact.