Shipping & packaging
Carton Volume vs Load Envelope in Pallet Cube
There are two honest ways to measure how much of a pallet’s cube a load uses, and they disagree whenever the cartons don’t completely fill the load’s outline.
Ready to try the tool this guide describes?
The load envelope
The envelope is the box around the whole load: its outer length, width, and height above the deck. It counts every gap inside it as used, because nothing else can go there.
The carton volume
Carton volume adds up the cartons themselves: count × length × width × height. Gaps between cartons aren’t counted, so it measures how much of the cube actually holds cartons.
The same load, measured both ways
Forty cartons of 15 × 11 × 9.5 in, stacked with a little room around each, make a load whose outline measures 48 × 40 × 40 in. Against a 103,680 in³ cube, the envelope is 76,800 in³ (74.07%), while the cartons add up to 62,700 in³ (60.47%). The 14,100 in³ between them is air inside the load.
Side by side
| Measure | Volume | Share of a 103,680 in³ cube |
|---|---|---|
| Load envelope, 48 × 40 × 40 in | 76,800 in³ | 74.07% |
| 40 cartons of 15 × 11 × 9.5 in | 62,700 in³ | 60.47% |
| Gaps inside the envelope | 14,100 in³ | 13.6% |
Which one to use
- The envelope, when the question is how much pallet space the load takes up.
- Carton volume, when the question is how tightly the cartons are packed.
- Both, when you want to know how much air is built into the load.
What carton volume can’t prove
A carton total smaller than the cube doesn’t show that the cartons fit on the pallet. Fit depends on how the carton footprints tile the deck and how many layers fit under the limit — a layout question, not a volume one.
Carton Volume vs Load Envelope FAQ
- Why is carton volume lower than the load’s outline?
- Because the outline includes the gaps between cartons and any space the stacking pattern leaves. The difference is air inside the load.
- Can carton-volume utilization be higher than the envelope figure?
- Not for the same load. The cartons sit inside the envelope, so their volume can’t be larger. If it is, a measurement is off.
- How do I measure a load envelope?
- Measure the longest length, the widest width, and the height from the deck to the highest point, including any bulge, cap, or wrap.
- Does adding up carton volumes check that they fit?
- No. It is a sum of volumes; whether the cartons fit depends on their layout on the deck.
- What does a large gap between the two measures mean?
- A lot of air in the load — loose stacking, a pattern that leaves holes, or cartons smaller than the space they were stacked into.
Related guides
- Calculating Pallet Cube UtilizationFind the cube available above a pallet deck under your height limit, measure what the load fills, and turn it into a utilization percentage.
- Why Pallet Cube Stays Under 100%Three measurable reasons a full-looking pallet uses less than its whole cube — the height remainder, the footprint remainder, and gaps — with worked numbers.
Open the tool
Jump into Pallet Cube Utilization Calculator when you are ready to process your files.


