Shipping & packaging
What to Include When Measuring Loaded Pallet Height
A height limit applies to the whole loaded pallet, so everything that adds height counts — not just the pallet and the cartons.
Ready to try the tool this guide describes?
Start from the floor
Measure from the floor to the highest point of the load, with the pallet standing on a level surface. A height limit is usually about the overall height, not the cartons alone.
Things that add height
| Item | Counts toward the height? |
|---|---|
| The pallet deck | Yes — measure the empty pallet |
| Every carton layer | Yes |
| Slip sheets or tier sheets between layers | Yes, their thickness adds up |
| Top caps, corner boards, or a top board | Yes, if they sit above the cartons |
| Stretch wrap | Only where it bunches above the load |
Slip sheets add up
Thin sheets between layers seem negligible, but each one is added once. Five layers with a 0.25 in sheet under each add 1.25 in, so a load planned at exactly 60 in becomes 61.25 in.
Bulges and uneven tops
Cartons can bulge under the weight above them, and a top layer with fewer cartons can sit unevenly. Measure the actual load at its tallest point after wrapping, not just the planned figure.
Allow a margin
- Plan a little below the limit to absorb measuring error.
- Add the thickness of any sheets or caps to the carton height when planning layers.
- Recheck the height after the load is wrapped.
Measuring Loaded Pallet Height FAQ
- Does a pallet height limit include the pallet itself?
- Usually, yes: floor to the top of the load, pallet included. Check how whoever sets the limit measures it.
- Do slip sheets count toward pallet height?
- Yes. Their thickness is added once for every sheet in the stack.
- Should I measure before or after wrapping?
- After, at the tallest point, because wrapping and handling can change the top of the load.
- How do I plan layers with slip sheets?
- Add the sheet’s thickness to the carton height, then work out the layers as usual.
- What if my load is a little over the limit?
- Take off a layer or use shorter cartons. A load over the limit may not fit where it’s going.
Related guides
- Calculating Stack HeightHow to work out a loaded pallet’s height and the most layers under a height limit, with inch and millimeter examples and the room left over.
- Geometric vs Safe Stack HeightWhy the most layers that fit under a height limit isn’t the same as a safe stack: carton strength, load stability, conditions, and who decides.
Open the tool
Jump into Pallet Stack Height Calculator when you are ready to process your files.


