Illustration of a horizontal fill bar with a marker line near the end and a container outline above it

Shipping & packaging

How to Set a Container Utilization Target

A utilization target turns “fill the container better” into a number you can check each time. It only helps if the number is one your cargo can actually reach.

Ready to try the tool this guide describes?

Start from what your cargo can reach

Work out the best count your carton allows in your container, and its utilization. In an example container 232 × 92 × 94 in inside, 24 × 16 × 12 in cartons fit 357 in the arrangements checked: 81.99% of the volume. That is the practical ceiling for that carton.

Measure the gap to the target

Volume to go = target × inside volume − cargo volume. At an 85% target, the same load is 60,329.6 in³ — 34.91 ft³ — short. Divided by one carton’s 4,608 in³, that is about 13 more cartons by volume.

Check the target against a layout

Those 13 cartons don’t fit: 357 was already the best arrangement checked. A target above what the carton can reach can’t be met by loading better — only by changing the carton, the mix of cargo, or the container.

Targets compared

Targets compared comparison
TargetVolume to goReachable with 24 × 16 × 12 in cartons?
75%Already past (by 81.19 ft³)Yes
80%Already past (by 23.14 ft³)Yes
85%34.91 ft³No — the best arrangement checked is 81.99%
90%92.97 ft³No

Using a target well

  • Set it per product or per carton, not one number for everything.
  • Track it over loads to find where space is being lost.
  • Revisit it when cartons, products, or containers change.

Setting a Utilization Target FAQ

What utilization target should I set?
One your cargo can reach. Work out the best arrangement for your cartons first, then set the target at or a little below it.
How do I work out the volume left to a target?
Multiply the target by the inside volume and subtract the cargo volume. At 85% of 2,006,336 in³ with 1,645,056 in³ loaded, 60,329.6 in³ is left.
Why can’t I reach my target by adding cartons?
Because the volume left is spread around the container in strips too thin for a whole carton. Volume to go is not space a carton can use.
Should a mixed load have a different target?
Usually. Mixed sizes leave different gaps, so measure what your typical mix reaches and set the target from that.
Is a higher target always better?
Only if the load stays stable, secure, and within its weight limit. A target is about space, not safety.

Related guides

Open the tool

Jump into Container Space Utilization Calculator when you are ready to process your files.

← Back to all guides

More from Looty

Explore Looty’s Ecosystem

Discover more ways Looty can help you learn, organize, create, and make an impact.